Automotive Tank Sealing Kit

For the long-term coating of tanks of a volume of up to 80 litres (without baffle plates) or 60 litres (with baffle plates).

Consisting of:
1. 500 ml WAGNER Single-Component Resin for Tank Sealing
2. 250 ml WAGNER Rust Converter
3. 1000 ml WAGNER Rust Converter

WAGNER Single-Component Resin for Tank Sealing

Transparent inner coating that prevents rust formation on the inside tank surfaces and provides long-term protection against corrosion in any tank.

WAGNER Single-Component Tank Sealing Resin is resistant to leaded and unleaded fuel, ethanol/petrol blended fuels such as E5, E10 and E85, pure ethanol, pure petrol (gasoline), two-stroke mixtures, diesel fuel, aviation fuel, motor oil, transmission oil, hydraulic oil, mineral oil, synthetic oil, two-stroke oil, brightstock, coolant, and additives, such as WAGNER Bactofin Fuel Stabilizer.

As opposed to most two-component sealing compounds, WAGNER Single-Component Tank Sealing Resin does not become brittle and permanently retains a minimum amount of flexibility. This is very important as it means the inner coating bonds reliably even in case of later damage to the tank due to vibrations or minor accidents.

WAGNER Rust Converter

stops rust immediately.

WAGNER Rust Converter is a highly concentrated product that, when mixed with water, perfectly removes rust by infiltrating and detaching deep-seated rust layers. The extremely low viscosity of Wagner Rust Converter allows it to penetrate rust even in the tightest and hardest to get at places!

At the same time, the Rust Converter creates a dark grey phosphate layer on the metal surface which serves as a perfect corrosion inhibitor.

This dark grey layer (phosphate) left by this rust remover on iron and steel effectively protects metal surfaces from rust. The derusted surface is left perfectly cleaned and ready for final coating with paint, resin, lacquer, tar, wax, tin, zinc or plastic.

Application

WAGNER Automotive Tank Sealing Kit treats tanks of a capacity of 80 litres (without baffle plates) or 60 litres (with baffle plates).

It seals tank interiors made of steel (also alloys), aluminum, stainless steel, copper, brass and plastics such as carbon, GFRP, Kevlar, polyester or vinyl ester.
Even new tanks with smooth inner surfaces can be sealed with WAGNER single-component tank sealing resin; roughening is not necessary.
Note: WAGNER tank sealing resin cannot be used on tanks made of polyethylene or polypropylene, since these materials cannot be coated permanently.

Dosing

After the necessary preparatory works pour the needed quantity of WAGNER Single-Component Resin into the tank and shake vigorously; then carefully slosh it around. The resin should completely saturate all inner walls.

When the inner coating is dry to the touch and no longer sticky (after 12 - 24 hours), a second layer can be applied. The hardening time of the inner sealing in the tank is about 7 to 8 days.

Before you start your work, it is very important to read carefully the instructions on tank sealing.