Tank sealing set 160L

Complete set for the refurbishment of tanks up to 80L capacity

Maintain the condition and service life of your vehicle and preserve your fuel tank with the WAGNER tank sealing set consisting of the rust remover WAGNER RostFix and the one-component resin WAGNER TankFix!

This set contains

• 2x 500 ml WAGNER TankFix
• 2x 250 ml WAGNER RustFix
• 2x 1L WAGNER RostFix
• detailed working instructions

and is sufficient for the renovation of tanks with a capacity of up to 160 liters (without baffle plates) or 120 liters (with baffle plates).

WAGNER RostFix

stops rust immediately - and removes deep-seated layers of rust.

At the same time, the porous surface structure eaten away by corrosion is chemically healed - during treatment, a solid metal surface is created that can be painted, coated, tinned or even galvanized without any problems. Mechanical derusting is no longer necessary!

The dark gray layer (phosphating) that WAGNER RustFix leaves on iron and steel effectively protects metal surfaces against rust.

Treatment with WAGNER RostFix considerably improves the rust protection of the metal and the adhesion of the final protective treatment. For non-ferrous metal surfaces such as aluminum or zinc sheet, WAGNER RostFix is suitable for pre-priming (etching) the bare surface. It is therefore also worth treating new, rust-free metals with WAGNER RostFix.

WAGNER TankFix

High-quality, transparent, ready-to-use fuel tank sealant for sealing and restoring tanks in need of renovation.

WAGNER TankFix saves every tank by installing a protective inner tank. Even fuel tanks that already smell, weep or drip are usually 100% watertight again after sealing!

Unlike most two-component sealants, WAGNER TankFix does not become brittle and permanently retains a minimum degree of flexibility. It therefore remains elastic and flexible after drying and can reliably compensate for the expansion and contraction of a metal tank caused by natural temperature fluctuations. In contrast to the brittle 2k coatings, this means that NO "micro-cracks" are formed which can be infiltrated by the fuel and therefore our tank sealant CANNOT flake off and even resists dents from minor accidents.

The water-like consistency and long working time of our tank sealing resin enable thorough and reliable work. This also gives you the security of coating, sealing and preserving the tank completely and without "gaps" with our resin.

Area of application

Tanks with a capacity of up to 160 liters (without baffle plates) or 120 liters (with baffle plates) can be treated with this tank sealing set.

Tank interiors made of sheet metal, steel (including alloys), aluminum, stainless steel, copper, brass and plastics such as carbon, GRP, Kevlar, polyester or vinyl ester can be sealed.

Even new tanks with flawless inner surfaces can be sealed with WAGNER TankFix, roughening is not necessary.
WAGNER Tankfix cannot be used on tanks made of polyethylene or polypropylene, as these materials cannot be permanently coated.

Application & dosage

After the necessary preparatory work (derusting, degreasing), pour the required amount of transparent WAGNER TankFix into the tank depending on the tank size and shake it vigorously, then carefully swivel it out. The resin should completely wet all areas of the inner walls.

After the first layer has dried and is no longer sticky (after approx. 12 - 24 hours), a second layer can be applied.

The coating is fully cured after approx. 7 to 8 days.

Before starting work, please read the instructions for tank sealing (available to download as a PDF below and enclosed with the set in paper form) carefully.